Channel: (select a channel number from the list)
This is the number of the channel you want to program.

select a channel Channel 00 Channel 01 Channel 02 Channel 03 Channel 04 Channel 05 Channel 06 Channel 07 Channel 08 Channel 09 Channel 10 Channel 11 Channel 12 Channel 13 Channel 14 Channel 15 Channel 16 Channel 17 Channel 18 Channel 19 Channel 20 Channel 21 Channel 22 Channel 23 Channel 24 Channel 25 Channel 26 Channel 27 Channel 28 Channel 29 Channel 30 Channel 31 Channel 32 Channel 33 Channel 34 Channel 35 Channel 36 Channel 37 Channel 38 Channel 39 Channel 40 Channel 41 Channel 42 Channel 43 Channel 44 Channel 45 Channel 46 Channel 47 Channel 48 Channel 49 Channel 50 Channel 51 Channel 52 Channel 53 Channel 54 Channel 55 Channel 56 Channel 57 Channel 58 Channel 59 Channel 60 Channel 61 Channel 62 Channel 63

Unit Word or Status Format: (select an item from one list)
The unit word is a one word unit description that will be given after the reading. It is optional. When a unit word is used, the telemetry and status is set automatically.

The channel may be designated as a status channel with options for off/on readings. For status channels, the trip point between low and high readings is equivalent to a telemetry reading 1020 or about half a volt input for a high/on reading. Status channels do not have unit words.

An item followed by a * indicates the factory default setting.

select unit word none* amperes degrees hours kilovolts kilowatts milliamps millivolts milliwatts minutes percent percent power power ratio reflected volts watts or select telemetry and status format none* completely silent channel channel ID only, no telemetry or status telemetry only, no units or status telemetry with units and auto status on/off* "status off" or "status on" "off" or "on" "main" or "auxiliary" "status 1" or "status 2" "night" or "day" "normal" or "alarm" "normal" or "intrusion" "normal" or "fire" "status A" or "status B" "power failure" or "normal" "normal" or "EAS alarm"

Maximum Reading and Decimal Point: (select a value from the list)
Choose a reading from the list that is larger than the maximum expected channel reading. This sets the scale and decimal point position for the channel.

An item followed by a * indicates the factory default setting.

select max scale 8160 4080 2040* 1020 816.0 408.0 204.0 102.0 81.60 40.80 20.40 10.20 8.160 4.080 2.040 1.020

Tracking (Linear/Logarithmic Scale): (select one)
Telemetry samples follow either a linear scale or a logarithmic scale. The device determines this setting. Most readings are linear. Power readings may be logarithmic. Information for setting up indirect power readings can be found here.

linear
logarithmic

Auto Control relay: (select one)
The auto control relay provides an auxiliary contact closure for equipment that requires a switch closure to operate (such as an antenna monitor). When auto control relay is enabled, the off/lower relay will engage whenever the channel is selected. This is not normally enabled.

enable auto control relay

Results: (program the RFC-1/B)
Program the following values into the address' shown.

At memory address: program value:


At memory address: program value:


At memory address: program value:


At memory address: program value: